XJM9 is suitable for processing miter edge, bottom edge and arrise on glass piece with different size and thickness. Miter spindle and front arise spindle are moving along with the front beam, so it is very easy to adjust miter angle and processing thickness. The miter edge and bottom edge are as bright as original after processing. Product description: 1.Front beam is electrical controlled. 2.Input and output conveyors adopt timing belt which can improve the stability of transmission. And[...]

X371 is suitable for processing beveling edge on glass piece with different size and thickness. Rough grinding, fine grinding and polishing of the bevel edge and grinding of bottom edge can be finished at one time. The bevel edge after processing is as bright as original. Product description: 1.Front beam is controlled by manual 2.Input and output conveyors adopt timing belt which can improve the stability of transmission. And the timing belt is easy to replace during maintaining. 3.Water tank[...]

XZJ125 is suitable for drilling flat glass piece. Product description: 1. Different sizes of holes can be drilled with different diameters of bits. 2. It is high working efficiency and easy operation. 3.Two options: Semi-automatic: Lower drilling bit is controlled by a cylinder while the upper bit is operated by manual Automatic: Both of the lower and upper drilling bits are fed by cylinder. Technical parameters: 1.Hole Diameter: φ5~φ130 (φ220) mm 2.Glass thickness: 4 ~19 mm 3.Max.[...]

I.Function: This automatic vertical stone profile machine can be used to profile marble, granite, artificial stone, glass and ceramics etc, which is for cabinet, window sill, stair, stringcourse, stone table etc. II.Design concept: 1.Stone may be damaged if it’s lying for processing due to its natural characteristic. Vertical structure of machine just reduces the loss ratio of material. 2.This machine is designed on the basis of glass processing machine. Combining more than 20 years working[...]

Product description: 1. Front beam is controlled by manual 2. Input and output conveyors adopt timing belt which can improve the stability of transmission. And the timing belt is easy to replace during maintaining. 3. Water tank is stainless steel. 4. A special design of the in-feed section for controlling the grinding amount of glass without adjusting each spindle individually. 5. Front beam and rear beam are processed by CNC processing center. 6. Brand of low-voltage electrical apparatus[...]